Figure 4C-22. Removing (or
F i g u r e 4C-24. Removing Ground
Installing) Oil Pump Idler Gear
S l e e v e from Housing
6. Install seal ring (16) onto pump hub
4. Install the freewheel rollers and
springs
into
the
stator
cam
(see
(17).
Figure 4C-25 on page 4C-22). Rollers
STATOR. To rebuild the stator, pro-
and springs may be retained with a
ceed as follows (see Figure 4C-39 on
h e a v y coating of oil soluble grease.
5. lnstall the springs in the deep end of
1. Remove rollers (4) and springs (3)
the stator pocket, with the end of the
from stator (2).
spring contacting the roller toward the
bore of the stator (see Figure 4C-26 on
2. Do not remove the rivets from the sta-
tor assembly. If any part of a stator as-
sembly is worn or damaged, the assembly
must be replaced.
CONVERTER TURBINE ASSEMBLY. To
rebuild the turbine assembly, proceed as
3. Clean and inspect parts as explained
follows (see Figure 4C-40 on page
under "Cleaning and Inspection" on page
1. Remove snap ring (14) from converter
turbine (1, Figure 4C-39 on page
2. Remove sprag clutch race (17) with
bearing assembly (15) and retainer (16).
3. Press bearing assembly (15) from race
(17) and remove retainer (16).
4. Remove sprag assembly (18) from
converter turbine (1, Figure 4C-39 on
5. Do not remove the rivets from the
turbine. If the turbine assembly is worn
or damaged, the assembly must be re-
placed.
6. Clean and inspect parts as explained
under "Cleaning and Inspection" on page
F i g u r e 4C-23. Removing Ground
Sleeve
Transmissions