F i g u r e 4C-31. Removing (or
Figure 4C-29. Removing (or
Installing) Drive Gear and Shaft
Installing) Clutch Pressure
Regulating Valve
12. Clean and inspect the parts as ex-
plained under "Cleaning and Inspection
page 4C-25). Use puller J4852 or a steel
on page 4C-10.
disk 1/4 x 1.370 inch (6.35 x 34.798 mm)
in diameter. Remove the pipe plug from
13. If sleeve (25) was removed from the
the rear of the pump body. Place the
oil pump body, install a new
disk in the slot behind the sleeve, align-
replacement. Press the new sleeve with
ing the disk with the sleeve. Insert a
the chamfer on the inside diameter facing
drift through the pipe plug hole in the
up,
into
the
body
until
it
is
firmly
rear of the pump body and place the
seated. Use tool J 4850 for installing the
drift against the disk. Press or drive
sleeve.
the sleeve out of its bore.
14. If bearing assembly (23) and seal
11. Do not remove plugs (28, 29, 30 and
ring (22 were removed from oil pump
31 Figure 4C-41 on page 4C-36) from
body
(27),
install
new
replacements.
In-
body
stall the bearing, pressing against the
(27) unless replace is necessary or for
numbered end of the bearing cage, flush
cleaning purposes. If necessary, remove
to 0.090 to 0.100 inch (2.286 to 2.540
the plugs.
mm) below the edge of the bearing bore.
F i g u r e 4C-32. Removing Needle
F i g u r e 4C-30. Removing (or
Bearing from Pump Body
Installing) Oil Pump Driven Gear