TM 5-3810-305-23
0086
INSTALLATION - Continued
14.
Near center of vehicle install tie wrap (Figure 12, Item 2) on cable (Figure 12, Item 10) to secure cable
to vehicle.
15.
Install two clamps (Figure 12, Item 11), flatwashers (Figure 12, Item 7), washers (Figure 12, Item 8) and
locknuts (Figure 12, Item 9) on cable (Figure 12, Item 10).
16.
Install clamp (Figure 12, Item 3), washers (Figure 12, Items 4 and 5), nut (Figure 12, Item 6) to secure two
cables (Figure 12, Item 1) under vehicle. Install three tie wraps (Figure 12, Item 2) on cables to secure cables
to bottom of vehicle.
2
3,4,5,6
7
8
1
9
11
10
M2117105
Figure 12.
Transmission Cable Installation.
END OF TASK
ADJUSTMENT
Two-Wheel Four-Wheel Cable
1.
Put lever in cab into two-wheel drive position.
2.
Pull shaft spool on transmission to full out position.
3.
Clamp cable to bracket aligning groove in cable with groove in clamp.
4.
Thread yoke jam nut all the way onto rod end. Thread yoke onto rod end and adjust to insert pin.
5.
Check lever in cab for full movement from stop to stop. Adjust yoke if lever is not centered between stops.
6.
Tighten jam nut on yoke.
7.
Insert cotter pin into pin.
8.
Check cables (Figure 12, Item 10) and (Figure 12, Item 1) for freedom of movement.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00093)
