TM 5-3810-305-23
0096
DISASSEMBLY - Continued
NOTE
Hub seal runner remains on pivot and spindle when hub assembly is removed.
2.
Remove hub seal runner (Figure 7, Item 1), hub seal (Figure 7, Item 2), and bearing cone (Figure 7, Item 3)
from hub (Figure 7, Item 5).
NOTE
Remove hub seal runner only if inspection proves necessary.
3.
If hub seal runner (Figure 7, Item 1) is damaged, remove 15 bolts which attach brake assembly to pivot and
spindle assembly, and remove brake assembly.
WARNING
Wear protective equipment while heating and handling seal runner. Failure to follow this
warning may cause serious injury to personnel.
4.
Remove hub seal runner (Figure 7, Item 1), if necessary. Apply moderate heat and use pry bar to remove seal.
Discard seal.
5.
Remove 10 studs (Figure 7, Item 7), if necessary, from hub (Figure 7, Item 5).
6.
Remove two bearing cups (Figure 7, Items 4 and 6) from hub (Figure 7, Item 5) if inspection proves necessary.
END OF TASK
CLEANING
Clean parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSPECTION
1.
Inspect parts IAW General Maintenance Instructions (WP 0162).
2.
Inspect ring gear carrier assembly for deformed or scored teeth.
3.
Inspect wheel hub and studs for damage.
4.
Check inner portion of hub for damaged teeth, rough spots on bearing surface, or cracks.
5.
Inspect studs for deformed shanks or damaged threads.
6.
Inspect all parts for wear, pitting, cracks, or corrosion. Replace if necessary.
END OF TASK
0096-6
03/15/2011Rel(1.8)root(maintwp)wpno(M00106)
