TM 5-3810-305-23
0138
CLEANING
Clean parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSPECTION
Inspect parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
ASSEMBLY
1.
Install bushings (Figure 4, Item 9) in handles (Figure 4, Item 1).
2.
Install two bushings (Figure 4, Item 4) in bracket assembly (Figure 4, Item 5).
3.
Install pin (Figure 4, Item 8) by pushing through bushing (Figure 4, Item 4) and bracket assembly
(Figure 4, Item 5).
4.
Install two washers (Figure 4, Item 6) on pin (Figure 4, Item 8).
5.
Install handle (Figure 4, Item 1) and washer (Figure 4, Item 6).
6.
Continue pushing pin (Figure 4, Item 8) and install tube (Figure 4, Item 7), washer (Figure 4, Item 6), handle
(Figure 4, Item 1), washer, tube, two washers, and handle.
NOTE
Add washers as required to minimize end play in handles without causing binding.
7.
Secure pin (Figure 4, Item 8) in place with washers (Figure 4, Item 6) and new cotter pins (Figure 4, Item 2).
0138-4
03/15/2011Rel(1.8)root(maintwp)wpno(M00154)