TM 5-3810-305-23
0155
DISASSEMBLY - Continued
4.
Remove two spacers (Figure 2, Item 11), washers (Figure 2, Item 12), sheaves (Figure 2, Item 13), and shaft
(Figure 2, Item 2) from cable side plate (Figure 2, Item 1).
5.
Remove grease fitting (Figure 2, Item 14) from sheave (Figure 2, Item 13).
6.
Press bushing (Figure 2, Item 10) out of sheave (Figure 2, Item 13), if necessary.
7.
Remove locknut (Figure 2, Item 4), thrust bearing (Figure 2, Item 5), trunnion (Figure 2, Item 7), grease fitting
(Figure 2, Item 8), and latch kit (Figure 2, Item 9) from hook (Figure 2, Item 10). Discard locknut.
8.
Remove trunnion (Figure 2, Item 7) and hook (Figure 2, Item 10) as an assembly.
9.
Press bushing (Figure 2, Item 6) out of trunnion (Figure 2, Item 7), if necessary.
10.
Remove three capscrews (Figure 2, Item 3) from cable side plate (Figure 2, Item 1).
1
2
11
12
3
13
14
10
12
11
4
5
6
7
10
8
9
M0621105
Figure 2.
Hook Block Disassembly.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00171)