TM 5-3810-305-23
0158
CLEANING
Clean parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSPECTION
Inspect parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSTALLATION
Swing Bearing Assembly
WARNING
Weight of swing bearing is approximately 187 lb (85 kg). Use adequate lifting equipment to
lift and support swing bearing. DO NOT lift over personnel or let personnel walk underneath
suspended load. Failure to follow this warning may cause injury or death to personnel.
1.
Install two lifting eye bolts in swing bearing 180 degrees apart. Attach lifting device and lift swing bearing
(Figure 5, Item 2) over rotary manifold and electrical collector ring. Locate mark made during removal and line
up swing bearing inspection plug retaining pin with mark.
2.
Install 22 capscrews (Figure 5, Item 1) to swing bearing (Figure 5, Item 2) and tighten to 722 ft-lb (979 Nm)
in sequence shown in Figure 5.
3.
Install fitting (Figure 5, Item 4) to inside swing bearing (Figure 5, Item 2).
4.
Connect lubrication hose (Figure 5, Item 3) to fitting (Figure 5, Item 4).
0158-7
03/15/2011Rel(1.8)root(maintwp)wpno(M00175)
