TM 5-3810-306-20
SIDE CONSOLE AND ACCESS PANEL REPLACEMENT
TOOLS: General mechanic’s tool kit: automotive (5180-00-177-7033)
SUPPLIES:
Lockwashers (Item 2, Appendix C) (5 required)
EQUIPMENT CONDITIONS: Disconnect ground cable at shunt. (Refer to page 8-109.)
Operator’s seat and pedestal removed. (Refer to page 15-27.)
REMOVAL:
NOTE
Use this task to remove and install
side console (2); front and rear
console access panels. Side console
(2) and front access panel (1) is
shown.
1.
REMOVE ACCESS PANEL (1).
a.
Hold access panel (1) in place.
b.
Remove five capscrews (3) and lockwashers (4).
Discard lockwashers (4).
c.
Remove access panel (1).
2.
REMOVE SIDE CONSOLE PANEL (2).
a.
Remove six screws (5) and grommets (6).
b.
Unscrew two shifter knobs (7) and one swing
brake knob (8).
c.
Remove three screws (9) and bubble level (10).
d.
Remove roll pin (13) from park brake control
knob (15). Remove nut (14) and park brake
control valve from panel.
e.
Disconnect electrical connectors to heater
temperature control switch (16)
.
8-21
