FUEL TANK COVER AND LADDER REPLACEMENT

TM-5-3810-306-20 Container Crane 40-Ton Rough Terrain Model RTB75CC Manual
Page Navigation
336

TM 5-3810-306-20 e. Remove sixteen capscrews (11), flatwashers (12), lockwashers (13) and hex nuts (14) from front side cover (15) and rear side cover (16). Discard lockwashers (13). f. Support weight of side covers (15 and 16) and remove ladder support (17) and ladder (18). NOTE Prior to removing leveling lockwashers, mark location, position and quantity. Replace in same order, add or relocate as required. g. Remove three capscrews (19), lockwashers (20), flatwashers (21) and leveling lockwashers (22) securing front side cover (15) to frame weld nuts. Discard lockwashers (20) and (22). h. Remove grab handrails (23) by removing capscrews (24), lockwashers (25) and flatwashers (26). Discard lockwashers (25). CAUTION Use care when removing front side cover to prevent damaging fuel tank filler neck. i. Using a suitable lifting device remove front side cover (15). j. Remove nuts (28), lockwashers (29), flatwashers (30) and leveling lockwashers (31) securing rear side cover (16). Discard lockwashers (29). k. Using a suitable lifting device, remove rear side cover (16). INSTALLATION: 1. INSTALL FUEL TANK COVER AND LADDER. a. Position rear side cover (16) and secure with leveling lockwashers (31), flatwashers (30), new lockwashers (29) and nuts (28). b. Position front side cover (15) at frame weld nuts and secure with three capscrews (19), new lockwashers (20), flatwashers (21) and new leveling lockwashers (22). c. Position ladder (18) between covers. Align ladder support (17) and secure with sixteen capscrews (11), flatwashers (12), new lockwashers (13) and hex nuts (14). d. Connect tire inflator fittings (10) to ladder (18). Secure with coupling nut (9) and install body (8). e. Install grab handrails (23) and secure with capscrews (24), new lockwashers (25) and flatwashers (26). f. Install twenty-three machine screws (2) and flatwashers (3). Install retaining nuts (27) where applicable. g. Install eighteen new lockwashers (4) and nuts (5). h. Install four self-tapping screws (6) to secure plate (7). 2. CONNECT GROUND CABLE AT SHUNT. (REFER TO PAGE 8-109.) END OF TASK 15-20

Privacy Statement
Press Release
Contact