Section XXVII. CARRIER CAB AND FENDERS
250. General
(2) Inspect the window mounting gasket for
damage and inspection glass for cracks
The pressed steel-constructed carrier cab is
and chipped edges.
mounted on the left-front side of the carrier frame. It is
(3) Replace damaged parts as necessary.
designed to accommodate only the driver. It can be
removed as a complete unit. The front fenders are
c. Installation. Install the side window glass, and
bolted in place and can be removed, if necessary, to
the rear window glass, as illustrated on figure 154.
facilitate overhaul of the carrier. The rear fenders are
bolted to the side rails.
253. Engine Access Panel
251. Windshield and Small Side Glasses
a. Removal. Remove the engine access panel as
instructed on figure 155.
are removed in the same manner as the door window
and windshield glass in the crane (para. 210).
b. Cleaning, Inspection, and Repair.
(1) Clean all parts with an approved cleaning
solvent.
are installed in the same manner as the door window
(2) Inspect the access panel for cracks,
and windshield glass in the crane (para. 210).
bends, and dents.
Weld all cracks.
Replace an unrepairable panel.
252. Side Window Glass, and Rear Window Glass
(3) Repair or replace damaged parts as
necessary.
a. Removal. Remove the side window glass, and
rear window glass, as instructed on figure 154.
c. Installation. Install the engine access panel as
illustrated on figure 155.
b. Cleaning and Inspection.
(1) Clean all parts with an approved cleaning
solvent.
Figure 154. Side window glass, and rear window
glass, removal and installation.
Figure 155. Engine access panel and operator's
seat, removal and installation.
AGO 6819A
173
