TM5-3810-305-10Removing and Stowing Parts Used forSeparation1.2.3.4.When upperstructure is down, continue to payout approximately 18 ft (5.49 m) to removetension on hoist cable.Shut engine off.Block cable at winch drum with a woodenb.wedge (Figure 5-6) to prevent cable from un-winding.c.Dismantle and restow lift arm ( 16) as follows:a. Remove hoist line from lift arm (16) by re-d.moving pin (12) connecting adjustabletruss rod (11 ) to top of mast (3, Figure 5-31).e.Figure 5-6. Wedge Block in Winch DrumWeight of the lift arm is approxi-mately 95 lb (43 kg), Use twopeople to properly support the liftarm. Failure to follow thisprocedure could cause DEATHor serious injury.Manually lower lift arm (16) down towardboom.Remove sheave (14) from clevis on liftarm (16). This will leave the cable slack.Remove adjustable truss rod (11 ) by re-moving pin (12) from top of lift arm (16).Remove bottom pin (17) and lift arm (16)from mast (3, Figure 5-3 1). Restow instorage location B (Figure 5-11) on rightside of boom.Figure 5-31Assembling theMast5-22
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
