TM5-3810-305-10
2. Start engine. Position carrier next to upper-
structure as follows:
a.
b.
c.
d.
Extend outrigger beams and pads down
close to ground.
Using swing lever, rotate swing bearing to
unlocked position with cam roller on axle
lockout valve, located at rear, bottom of
rotary manifold, centered in notch.
Maneuver carrier over toward upperstruc-
ture, positioning right front outrigger beam
in under upperstructure (Figure 5-34).
Vehicle must be level to prevent
possible loss of control of upper-
structure when lifting off of
ground. DEATH or serious
injury may result if upperstruc-
ture gets out of control
Figure 5-34 P o s i t i o n i n
g
O u t r i g g e
With carrier in place, extend outrigger
beams, raising carrier off ground at all
four corners. Level carrier, using bubble
level on right side of console.
5-27
