TM5-3810-305-10b.c.d.Weight of mast is approximately98 lb (44 kg). Use two people toproperly support and lift mast.Failure to follow this procedurecould cause DEATH or seriousinjury.Lift mast (3) up off pivot bearing and stowin storage location D (Figure 5-4) onupperstructure.Disconnect H-10 and H-11 winch exten-sion hoses from both upperstructure andunderneath carrier. Install dust caps ondisconnect fittings at winch valve on rightside of carrier.Roll up hoses H- 10 and H- 11 and connecte.f.g.Remove dust caps and plugs from tool box(three sizes, two of each). Plug or capopen hose ends and all open fittings onrotary manifold (Figure 5-20). Lock dip-stick cap on hydraulic tank.Maintain normal rear axle oscillation withrotary manifold disconnected from upper-structure. Remove wrench from tool boxand, using two mounting capscrews andfour washers, install wrench (Figure 5-32)with pin end engaged in hole of torquearm bracket on rotary manifold. Usebreaker bar and 36 mm socket to tightentwo mounting capscrews.Thread remaining 16 mounting capscrewsand 32 washers back into threaded holes ofswing bearing.ends together (Figure 5-14). Return themto tool box.Figure 5-14. Extension HosesFigure 5-4. Storage Location D5-24
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
