TM5-3810-305-10Preparation of Carrier for Transport1. Lower carrier to ground, using the followingprocedure:a.b.Start engine. Raise outrigger beams. Liftoutrigger pads that are underneath boomjust enough to clear ground.CAUTIONDo not allow outrigger beam,located under upperstructure, tocontact winch hoses. Failure tofollow this procedure could causedamage to equipment.Using swing lever, rotate swing bearing tounlocked position with cam roller on axlelockout valve, located at rear, bottom ofrotary manifold, centered in notch.Figure 5-20 Location of Boom Hoist Cylinder HosesAfterDisconnection2.3.NOTEThis position will permit oscilla-tion of rear axle when maneuver-ing carrier away from upperstruc-ture.Use crab steering and short forward-reversemovements to move the carrier until it is clearof upperstructure.Prepare outriggers for travel, using the fol-lowing procedure:a.b.c.Raise outrigger beams to travel position.Shut engine off.Remove nuts, washers, bolts and padsfrom ends of outrigger beams. Reinstallbolts, washers and nuts after pads areremoved.Figure 5-32 RearAxleOscillation5-25
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
