TM 5-3810-305-23
0160
DISASSEMBLY - Continued
CAUTION
Use care when removing bearing; DO NOT damage bore of commutator. Failure to follow
this caution may result in damage to equipment.
10.
Remove inner bearing (Figure 8, Item 1), thrust washer (Figure 8, Item 2), thrust bearing (Figure 8, Item 3),
thrust washer (Figure 8, Item 4), inner seal (Figure 8, Item 5), and back-up washer (Figure 8, Item 6) from
housing (Figure 8, Item 8). Discard inner bearing and inner seal.
11.
Remove retaining ring (Figure 8, Item 7) from housing (Figure 8, Item 8).
12.
Remove and discard bearing (Figure 8, Item 9).
1
2
3
4
5
8
6
7
9
M0467105
Figure 8. Swing Motor Disassembly.
END OF TASK
CLEANING
Clean parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSPECTION
1.
Inspect parts IAW General Maintenance Instructions (WP 0162).
2.
Inspect bolt head recesses for damage that would prevent bolt heads from sealing properly.
3.
If inspection reveals damage to rotor assembly, set commutator, or housing, swing motor should be replaced
as an assembly. Time parts are all matched to each other and are not serviced separately.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00179)
