TM 5-3810-305-23
0160
ASSEMBLY
NOTE
Coat all internal parts with hydraulic oil before assembling.
1.
Install retaining ring (Figure 9, Item 7) with rounded surface of ring facing in toward larger housing
(Figure 9, Item 8) cavity.
2.
Install back-up washer (Figure 9, Item 6) and new inner seal (Figure 9, Item 5). Inner seal must be installed
flush against back-up ring with seal lip facing out toward thrust washer.
NOTE
Use a bearing and press when installing bearings.
3.
Install thrust washer (Figure 9, Item 4), thrust bearing (Figure 9, Item 3), thrust washer (Figure 9, Item 2),
and new inner bearing (Figure 9, Item 1). Press inner bearing into a depth of 0.125 to 0.135 inches
(3.18 to 3.43 mm).
4.
Apply molybdenum grease to new bearing (Figure 9, Item 9) rollers. Turn housing (Figure 9, Item 8) over and
install new bearing to a depth of 1.598 to 1.618 inches (40.59 to 41.10 mm). Make sure new bearing is not
cocked and is square to housing.
1
2
3
4
5
8
6
7
9
M0467105
Figure 9.
Swing Motor Assembly.
03/15/2011Rel(1.8)root(maintwp)wpno(M00179)