TM 5-3810-306-20
VTM POWER CABLE HARNESS
TOOLS: General mechanic’s tool kit: automotive (5180-00-177-7033)
SUPPLIES:
None
EQUIPMENT CONDITIONS: Disconnect ground cable at shunt. (REFER TO PAGE 8-109.)
REMOVAL:
1.
REMOVE VTM POWER CABLE ARNESS (6).
a.
Tag and disconnect black (1) and white (2) wires
located in battery box.
b.
Open DCA box cover by loosening retaining
screws (3).
c.
Tag and disconnect black (1) and white (2) wires
from terminal strip.
d.
Remove grounding wire (4).
e.
Loosen strain relief fitting (5) and remove cable
from DCA box.
INSTALLATION:
1.
INSTALL VTM POWER CABLE HARNESS (6).
a.
Route cable through cable clamps.
b.
Route cable through strain relief fitting (5) in
DCA box and connect tagged wires (1) and (2).
c.
Tighten strain relief fitting (5).
d.
Connect grounding wire (4).
e.
Connect opposite ends of tagged wires in battery
box.
f.
Secure DCA box cover.
2.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO PAGE 8-109.)
3.
PERFORM STE/ICE TEST TO CHECK FOR
PROPER OPERATION. (REFER TO PAGE 3-57).
END OF TASK
8-74
