TM 5-3810-306-20
e.
Connect wires to front outrigger solenoids as
tagged.
f.
Connect wires to outrigger selector solenoid as
tagged.
g.
Connect wires to rear axle oscillation lockout
solenoid as tagged.
h.
Connect wires to air dryer as tagged.
i.
Connect wires to fuel gauge sender as tagged.
j.
Connect three superstructure harness connector
plugs at swivel mount as tagged.
k.
Connect wires to back-up light switch as tagged.
l.
Connect wires to transmission selector solenoid
as tagged.
m.
Connect blackout lights harness connector plug
as tagged.
n.
Connect two engine harness connector plugs as
tagged.
o.
Connect wires to rear axle not centered switch
as tagged.
p.
Connect wires to rear outrigger solenoids as
tagged.
q.
Connect wires to back-up alarm as tagged.
r.
Connect wires to left and right rear marker lights
as tagged.
s.
Connect wires to left and right rear tail lights as
tagged.
t.
Install more tie straps as may be necessary to
support harness and prevent chafing.
2.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO PAGE 8-109.)
3.
CHECK ELECTRICAL SYSTEM FOR PROPER
OPERATION. (REFER TO TM 5-3810-30610.).
END OF’TASK
8-78
