TM 5-3810-306-20CARRIER HARNESSTOOLS: General mechanic’s tool kit: automotive (5180-00-177-7033)SUPPLIES:NoneEQUIPMENT CONDITIONS: Disconnect ground cable at shunt. (Refer to page 8-109.)REMOVAL:1.REMOVE CARRIER HARNESS.a. Tag and disconnect wires at left and right tail lights.b.Tag and disconnect wires at left and right rearmarker lights.c.Tag and disconnect wires at back-up alarm.d.Tag and disconnect wires at rear outriggersolenoids.e.Tag and disconnect wires at rear axle notcentered switch.f.Tag and disconnect two engine harnessconnector plugs.g.Tag and disconnect black out lights harnessconnector plug.h.Tag and disconnect wires at transmissionselector solenoid.i.Tag and disconnect wires at back-up lightswitch.j.Tag and disconnect three superstructureharness connector plugs at swivel.k.Tag and disconnect wires at fuel gauge sender.l.Tag and disconnect wires at air dryer.m.Tag and disconnect wires at rear axle oscillationlockout solenoid.n.Tag and disconnect wires at outrigger selectorsolenoid.o.Tag and disconnect wires at front outriggersolenoids.p.Tag and disconnect wires at left and right frontmarker lights.q.Tag and disconnect wires at left and right frontheadlights.r.Tag and disconnect all ground wires on carrierframe.s.Remove any tie straps and/or clamps securingharness to frame and remove carrier harness.2.INSPECT CARRIER HARNESS FOR DAMAGE,AND REPLACE PARTS OR HARNESS ASREQUIRED.INSTALLATION:1.INSTALL CARRIER HARNESS.a.Position carrier harness on frame and support byinstalling tie straps and/or clamps as required.b.Connect all ground wires to carrier frame astagged.c.Connect wires to left and right front headlights astagged.d.Connect wires to left and right front marker lightsas tagged.8-76
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
