Probable cause
Possible remedy
Probable cause
Possible remedy
Defective bearings -------------------Replace bearings
Worn or damaged clutch Replace
clutch disk
facings.
(pars. ,268-265).
Defective spline shaft ---------------Replace spline shaft
43. Carrier Transfer Case Noisy
Probable cause
Possible remedy
42. Carrier Gear Shifting Difficult
Loose transfer case ----------------- Tighten or replace bolts
Probable cause
Possible remedy
mounting bolts.
Broken or bent yokes ---------------Replace yokes or shifting
Defective gears ---------------------- Replace gears
bar
Defective bearings ------------------ Replace bearings.
Defective gear teeth -----------------Replace gear
Defective spline shaft --------------- Replace spline shaft
Housing and assembly -------------Replace housing assembly
out of alinement.
Section III. REMOVAL AND INSTALLATION OF MAJOR COMPONENTS OR AUXIUARIES
(5) Disconnect the cab heater (TM 5-3810-
44. Crane Cab Assembly
207-20).
a. Removal.
(6) Disconnect the master clutch linkage (TM
(1) Remove the front end attachments as
53810-207-20).
necessary (TM 53810-207-10).
(7) Remove the main drive chain case, chain,
(2) Remove the gear and chain guards and
and drive gear (TM 54810-207-20).
gantry sheave assembly (TM 5-3810-207-
(8) Remove the engine wiring harness (par.
20).
(3) Disconnect the control panel instruments
(9) Remove the clutch assembly (par. 84).
and engine controls (TM 5-3810-207-20).
(10) Remove the crane engine assembly as
(4) Remove the crane cab assembly from the
instructed on figure 2.
crane base as instructed on figure 1.
b. Installation.
b. installation.
(1) Install the crane engine assembly as
(1) Install the crane cab assembly as
illustrated on figure 2.
illustrated on figure 1.
(2) Install the clutch assembly (par. 86).
(2) Connect the control panel instruments and
(3) Install the engine wiring harness (par.
engine controls (TM 5-3810-207-20).
(8) Install the gear and chain guards and
(4) Install the main drive chain case, chain,
gantry sheave assembly (TM 5-810- 207-20).
and drive gear (TM 5-3810-207-20).
(4) Install the front end attachments as
(5) Connect the master clutch linkage (TM 5-
necessary (TM 543810-207-10).
3810-207-20).
(6) Connect the cab heater (TM 5-3810-207-
45. Crane Engine Assembly
20).
(7) Connect the fuel line (TM 5-3810-207-20).
a. Removal.
(8) Connect the battery cables (TM 5-3810-
(1) Remove the crane cab (par. 44).
207-20).
(2) Drain the cooling system (TM 5-3810-207-
(9) Fill the cooling system (TM 543810-207-
10).
20).
(8) Disconnect the battery cables (TM 5-
(10) Install the crane cab (par. 44).
3810-207-20).
(4) Disconnect the fuel line (TM 5-3810-207-
20).
TAGO 5030A
28
