TM5-3810-305-10e.f.g.h.Align left edge of wrench (Figure 5-32)with right side of lockout valve. Using a36 mm socket and breaker bar, removetwo capscrews and four washers attachingwrench to swing bearing and rotary mani-fold. Remove wrench and stow in toolbox. Capscrews and washers will beinstalled at a later time.Shut engine off.Remove remaining 16 capscrews and 32washers from top of swing bearing. Setthem aside, for reinstallation at a latertime.Check and clean top of swing bearing, ifnecessary, where upperstructure will bebolted down.i. Remove all dust caps and plugs from con-nectors on hoses and rotary manifold incenter of swing bearing (Figure 5-20).Stow caps and plugs in tool box.3. Attach winch extension hoses as follows:a.b.Remove two coiled extension hoses (Fig-ure 5-14) from tool box. Their ends areconnected together by quick disconnects,and are marked with ID tags reading H-10and H-11. Take them to right side ofcarrier.NOTEBe sure to keep the hoses andtheir quick disconnect ends cleanduring this procedure.Disconnect ends and uncoil hoses.Figure 5-32 Rear Axle OscillationFigure 5-20 LocationofBoomHoistCylinderHosesAfterDisconnection5 - 28
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
