LED ALERT MODULE REPLACEMENT

DUAL AIR PRESSURE GAUGE REPLACEMENT - cont

TM-5-3810-306-20 Container Crane 40-Ton Rough Terrain Model RTB75CC Manual
Page Navigation
167

TM 5-3810-306-20 LED ALERT MODULE REPLACEMENT TOOLS: General mechanic’s tool kit: automotive (5180-00-177-7033) SUPPLIES: Lockwashers (Item 7, Appendix C)(4 required) EQUIPMENT CONDITION: Disconnect ground cable at shunt. (Refer to page 8-98.) Right front control panel removed. (Refer to page 8-11.) REMOVAL: 1. REMOVE COVER (1) AND DISCONNECT ELECTRICAL CONNECTOR (4). a. Remove two screws (2) on module cover (1). b. Disconnect harness connector (4). 2. REMOVE LED ALERT MODULE (7). a. Remove four screws (5), lockwashers (6), and nuts (3). Discard lockwashers (6). b. Lift out module (7). 3. INSPECT WIRING FOR DAMAGED INSULATION OR TERMINALS. REPLACE IF DAMAGED. INSTALLATION: 1. INSTALL LED ALERT MODULE (7). a. Align LED alert module (7) with control panel slot. b. Install four screws (5), new lockwashers (6), and nuts (3). c. Install module cover (1) with. two screws (2). 2. CONNECT ELECTRICAL CONNECTOR (4). 3. INSTALL RIGHT FRONT CONTROL PANEL. (REFER TO PAGE 8-11.) 4. CONNECT GROUND CABLE AT SHUNT. (REFER TO PAGE 8-109.) 5. START ENGINE (REFER TO TM 5-3810306-10.) 6. MAKE SURE LED ALERT MODULE (7) INDICATORS LIGHT FOR SEVERAL SECONDS WHEN ENGINE STARTS END OF TASK 8-10

Privacy Statement
Press Release
Contact